Sprocket round turret* generator

*not only

Turret parameters


 
❔The diameter of the turret.
3

 
❔How many structural elements to generate for each elevation.
12

❔The list of slope angles, arranged from bottom to top, in degrees.
Pro tip: do not use angles over 90 for inverted slopes. Instead, use negative angles. Credit to TurdmanJones for finding this out.

     
❔An offset in the width axis. Note that this is relative to the root of the turret or the hull (see Apply to below).
   
❔An offset in the length axis. Note that this is relative to the root of the turret or the hull (see Apply to below).
   
❔An offset in the height axis. Note that this is relative to the root of the turret or the hull (see Apply to below).

❔The type of structural element to generate.

Apply to:
❔Apply both removing and adding the panels to the hull or to the turret.

     
❔If Remove existing panels is enabled, then all existing panels are removed from the turret or hull (as set by Apply to above).
If Only of selected type is enabled, then only panels of the selected type (as above) are removed. Otherwise all panels are removed.
This applies only if there is already data in the resulting code box.

 

 

Resulting code:

❔Copy this text.
If you used an existing blueprint, replace the entire file with this.
Otherwise, go to the blueprint file, find an element called "ext", and paste this text into the list.
Don't forget to back up your design before manually changing the text files!
Copied!  
❔Download the generated text as a file.
❔Clear the resulting code text box.
 
❔Upload an existing blueprint file.